Supreme Series Cartomizers
Empty Supreme Series High Performance Horizontal Coil Cartomizers . These cartomizers are reloadable and hold 1.1ml of e-liquid. They are available in an 808 thread for Supreme Series and a 510 thread for use with Joyetech 510 and eGo's. Reload each cartomizer approximately 10-15 times before replacing.
-Horizontal Coil heats the entire surface area of Poly Fill evenly creating
massive vapor with minimal effort.
-New enamal paint is an improvement over the former glued paper coatings
-New packaging list specs including ohms, # of coils, capacity etc.
-White, black and polished steel color options
510 are 1.8oHm and 808D1 are 2.6 +-0.2
1) De attach Cartomizer from battery.
2) Remove white rubber mouth piece.
3) Load 1 mL of e-Liquid (approximately 30 drops out of our dripper bottles) into the poly fill surrounding the airwick.
( Holding cartomizer at an angle and rotating while you load to assure even saturation leads to best performance)
4) After poly fill is fully saturated let stand on connection end for 1 minute to allow any possible access juice to drain out. ( Getting liquid into the airwick, overloading or reloading too many times can lead to leakage. If liquid leaks into battery it can cause your battery to short circuit and fail to work.)
5) Re attach plastic white cap or drip tip and its ready to be used.
(NOTE- You may need to "prime" your cartomizer by giving it a few puffs to pull your liquid to the correct spot. Cartomizer may not perform right if underloaded or not fully primed. If desired you can replace white end cap with a 510/808 Drip Tip.
Works With Drip Tip A,B,C,D,E,F,G and H